Verifying And Troubleshooting Sip Features - Samsung Ubigate iBG3026 Configuration Manual

Step
3
4

Verifying and Troubleshooting SIP Features

This section describes how to use the show command and debug command to
verify and troubleshoot the SIP feature of Ubigate iBG3026.
Using show commands
You can use the show command commands as follows to confirm or see the
current status of the SIP feature settings.
show sip-ua service
Shows the sip service status. The service status is 'up' or 'down'.
Example)
# show sip-ua service
SIP Service is up
© SAMSUNG Electronics Co., Ltd.
Command
srtp crypto
[AES_CM_128_HMAC_SHA1_32 |
AES_CM_128_HMAC_SHA1_80]
Example)
/configure/ dial-peer/voice/voip
100# srtp crypto
AES_CM_128_HMAC_SHA1_32
Exit
Example)
/configure/dial-peer/voice/voip
100# exit
Ubigate iBG3026 Configuration Guide/Ed.00
Purpose
Specifies SRTP crypto suite. You can
specify either
AES_CM_128_HMAC_SHA1_32 or
AES_CM_128_HMAC_SHA1_80 , or
both of them.
Exits the current mode
(Continued)
405