Dial Plan Mode - Samsung Ubigate iBG3026 Configuration Manual

The following number type can be used.
Abbreviated - Abbreviated representation of the complete number as
supported by this network.
International - Number called to reach a subscriber in another country.
National - Number called to reach a subscriber in the same country, but
outside the local network.
Network - Administrative or service number specific to the serving network.
Reserved - Reserved for extension.
Subscriber - Number called to reach a subscriber in the same local network.
Unknown - Type of number is unknown by the network.
For d etailed information about these numbering types, see ITU-T Recommendation
Q.931.

Dial Plan Mode

Dial Plan Mode
Dial plan mode is a mode that set global configuration for dial-plan
The Following are commands of dial-plan mode.
cp-tone
Example)
sbm/configure/dial-plan # cp-
tone kr
fxs-pattern tag full-fxs-pattern
ext-leng ext-pattern
Example)
sbm/configure/dial-plan # fxs-
pattern 1 802343849.. 4 49..
max-call num
Example)
sbm/configure/dial-plan #max-
call 512
© SAMSUNG Electronics Co., Ltd.
Command
Ubigate iBG3026 Configuration Guide/Ed.00
Purpose
The cp-tone command is to set the voice interface
of tone(ring, busy, cadence) for a specific country.
To create a global prefix that can be used to
expand the extension numbers of inbound and
outbound calls into fully qualified E.164 numbers in
toll by pass mode, use the fxs-pattern command.
The maximum number that could be configured is
5. Digit and dot(.) could be entered.
To set the maximum number of calls that a system
can handle, use the max-call command in dial plan
configuration mode. Default value is unlimited.
Range is from 1 to 10000.
583