Samsung Ubigate iBG3026 Configuration Manual page 608

CHAPTER 33. Routing and Digit Manipulation
Configuring Dial Peers
Configuring Dial Peers for Call Legs
When call enters Ubigate iBG3026, it is necessary to do dial-peer matching
for routing. On call bound to packet network after entering POTS interface,
Ubigate iBG3026 should do matching POTS dial-peer against inbound call leg.
It also should do matching VoIP dial-peer against outbound call leg. VoIP
incoming call is the opposite case.
Figure 33.4 shows the call legs and associated dial peers necessary to
complete a voice call.
Source
PBX A
Inbound oall leg
(POTS dial peer)
The following example shows the example of call made possible from number
0315854000 to 0234381000.
Figure 33.5 shows inbound POTS dial peer are outbound VoIP dial peer set in
originating Ubigate iBG3026. POTS dial peer displays the origination of call
after being matched to either calling-number or port information. On the other
hand, VoIP dial peer displays the termination of call by connecting with called
number and session target.
566
iBG3026 A
IP Network
Outbound oall leg
(VolP dial peer)
Figure 33.4 Matching Call Legs to Dial Peers
iBG3026 B
Inbound oall leg Outbound oall leg
(VolP dial peer) (POTS dial peer)
© SAMSUNG Electronics Co., Ltd.
Destination
PBX B