Samsung Ubigate iBG3026 Configuration Manual page 558

CHAPTER 31. Digital Voice Port
Step
8
9
10
11
Create DS0 Groups on a Digital T1 Trunk
This procedure is much like the same as the configuration of E1 trunk.
Step
1
2
3
4
5
v239# show voice port summary
PORT
======== == ========== ===== ==== ============= ============ ==
0/0/0
0/0/1
0/0/2
0/0/3
0/1/0:10 -- ---
516
Command
framing { esf | d4 }
linecode { b8zs |
ami }
Exit
show module
configuration t1
trunk#
Command
configure terminal
module t1 trunk#
cas-ds0-group ds0-
group-no
exit
show voice port
summary
CH SIG-TYPE ADMIN OPER IN STATUS
-- fxs-ls up
-- fxs-ls up
-- fxs-ls up
-- fxs-ls up
down
Purpose
Selects frame type for T1 or E1 line.
esf-Extended super frame framing format for T1.
d4-Super frame framing format for T1
disable-Disables E1 framer.
Specifies the line encoding to use.
The keywords are as follows:
ami-Specifies the alternate mark inversion(AMI)
line code type.(T1 and E1)
b8zs-Specifies the binary 8 zero substitution line
code type.(T1)
exit to the global configuration mode. Keep in
mind that no-shutdown is not necessary as the
settings are applied instantly.
Check out the status of the specified trunks and
the sanity.
trunk# is a simple notation of slot/sub-slot/port,
for convenience.
Purpose
Assumes the trunk becomes normal active according
to the steps above. Here the description starts with
configuring CAS signaling to trunk.
Enter the module configuration mode.
Enter the ds0-group number to create in this T1
trunk.
Exit module configuration mode.
Check if ds0-group is normally created.
Ds0-group created in the system is displayed in
the status of slot/sub-slot/port:ds0-group-no.
up on-hook
up on-hook
up on-hook
up on-hook
-- ----
(Continued)
OUT STATUS EC
idle y
idle y
idle y
idle y
---- y
© SAMSUNG Electronics Co., Ltd.