Configuring Basic Sip Gateway - Samsung Ubigate iBG3026 Configuration Manual

CHAPTER 28. SIP Gateway Management

Configuring Basic SIP Gateway

Configuring SIP Bind
This section describes the SIP bind feature. With this feature, you can specify
the source address of SIP signaling, and the source address for media stream
as well. You can specify the interface by Bind command or specify the IP
address directly by host ip-address command.
Restrictions for SIP Bind
The interfaces which you can specify as the source address of SIP signaling
and media stream via Bind command are ethernet, bundle and loopback.
Prerequisites for SIP Bind
You must shut down the VoIP service before executing Bind command or host
ip-address command. To execute the Bind command, it is necessary to set IP
address first to the interface to bind.
How to Configure SIP Bind
1.
setting the IP Address of the interface to be bound
This procedure should be executed first before executing the bind command.
Configuration Steps
−
−
−
−
Detailed Steps
Step
1 configure terminal
Example)
# configure terminal
2 Interface type number
Example)
/configure# interface Ethernet 0/0
356
configure terminal
interface
ip address
exit
Command Purpose
Enters global configuration
mode.
Enters interface configuration
mode to configure specific
interface.
© SAMSUNG Electronics Co., Ltd.