Show Port Trap Command - Avaya P333T User Manual

Chapter 6 Cajun Campus CLI – Layer 2
Example:
To display the status for port 4 on module 3:
Cajun_P330-N> show port 3/4
Port Name
------ --------------- --------- ---- ------ ------- ---- ---- -------------
3/4 John
Show Port Output Fields
Field
Port
Name
Status
VLAN
Level
Neg
Duplex
Speed
Type

Show port trap Command

Use the show port trap command to display information on SNMP generic
link up/down traps sent for a specific port.
The syntax for this command is:
show port trap [<mod_num>[/<port_num>]]
Example:
Cajun_P330-N> show port trap 1/1
Port 1/1 up/down trap is disabled
48
Status Vlan Level Neg
connected 1
Description
Module and port number
The name you assigned to the port
Status of the port (connected, no link, disabled, no Rmt Lnk)
VLAN ID of the port
Priority level of the port (normal or high)
The autonegotiation status of the port (enable, disable)
Duplex setting for the port (fdx, hdx)
Speed setting for the port (10, 100).
Port type, for example, 10BaseT, 10BaseFL, 100BaseTX,
100BaseFX MM, 100BaseFX SM, 10/100BaseTX
Dup. Spd. Type
normal enable half 10M 10/100Base-Tx
Avaya P333T User's Guide