Assigning The Initial Router Ip Address - Avaya P334T-ML Quick Start Manual

6. At the prompt, type reset. Type y and press Enter to reset the stack. After the Reset, log
in again as described above.
- At the prompt, type set ip route <dest> <gateway> and replace <dest> and
<gateway> with the destination and gateway IP addresses.

Assigning the Initial Router IP Address

Note:
This section is only applicable if you either purchased a preconfigured , or
Note:
purchased a Routing License Key Certificate and activated the License Key.
Tip:
Commands are shown as follows: set interface inband; parameters which
Tip:
you need to provide are shown in as follows: <vlan>
Note:
Assign the stack IP address as described in
Note:
page 24 before you assign the Initial Router IP Address.
If you purchased a preconfigured switch, go to step 3.
1. To request a License Key, go to: http//license-lsg.avaya.com.
2. To activate the License Key, type set license <module number> <license key>
routing where <module number> is the location of the switch in the stack and
<license key> is the number you obtained from the above Web site and press Enter.
3. If the is not the stack master or in standalone mode, open a session to it by typing
session <module number> where <module number> is the location of the in the
stack and press Enter
4. Type set device-mode router and press Enter.
- You will be prompted to reset the module.
5. Type y.
6. Wait for the module to restart and for the CLI prompt to reappear.
7. Type show device-mode and press Enter to ensure that the module is in router mode.
Note:
Assign the stack IPaddress as described in
Note:
page 24 before you assign the Initial Router IP Address.
8. Type session <module number> router where <module number> is the location
of the in the stack and press Enter.
Assigning the Initial Router IP Address
Assigning a Stack IP Address
Assigning a Stack IP Address
Issue 1 September 2005
on
on
25