Assigning P334T-Ml Initial Router Parameters - Avaya P334T-ML User Manual

configure the individual modules using either the CLI or the MSNM manager.
To configure the modules using the MSNM manager, see the MSNM manager User
Guide on the Management CD accompanying the module.

Assigning P334T-ML Initial Router Parameters

This section is only applicable if you either purchased a Layer 3 preconfigured
P334T-ML module or purchased a Routing License Key Certificate for P334T-ML
and activated the License Key. For information, on activating a Licence Key, see
Obtaining and Activating a License Key on page 43.
To configure the initial router parameters perform the following via the CLI:
1 Enter set device-mode router and press Enter.
You will be prompted to reset the module.
2 Type y.
Wait for the module to restart and for the CLI prompt to reappear.
3 Type show device-mode and press Enter to ensure that the module is in
router mode.
Note: Assign the stack IP address as described in Assigning P330's IP Stack Address
on page 40 before you assign the Initial Router IP address.
4 To access Router commands from the Master module, type the command
session <module number> router where <module number> is the
location of the P334T-ML in the stack, and press Enter.
The command prompt changes from Console> to Router-N#> where N is
the number of the router in the stack (see P330 Sessions on page 50).
5 Type configure and press Enter. The prompt Router-N(configure)#
appears.
Note: If the IP interface is not on VLAN #1, continue with step 6, otherwise skip to
step 8.
6 Create the management/routing VLAN. Use the command
set vlan <Vlan-id> name <Vlan-name> replacing <Vlan-id> by the
VLAN number, and <Vlan-name> by the VLAN name. Press Enter.
7 Create an IP interface name. Type:
Router(configure)# interface <interface-name>
Press Enter.
The Router(configure-if:<interface-name>)# prompt appears.
8 Assign the IP address and network mask of the IP interface you have created.
P334T-ML User's Guide
Chapter 4 Installation and Setup
41