Assigning A P333R-Lb Ip Stack Address - Avaya P333R-LB Quick Start Installation Manual

Prepare for Configuration
2. Ensure that the serial port settings on the terminal are:
9600 baud
●
8 bits
●
1 stop bit
●
no parity.
●
- If you reset or powered up the switch after connecting and configuring the terminal,
Welcome to P333R-LB appears followed by the Login Name prompt.
- If the login prompt does not appear, press a key on the terminal.
3. Enter the default login: root.
- The Password prompt appears
4. Enter the user level password: root.
- You can now establish a connection to the Router or the Master switch (indicated
when the SYS front panel LED is ON) using the Session commands and begin the
configuration of module, stack, or router parameters.

Assigning a P333R-LB IP Stack Address

Note:
All P333R-LB switches are shipped with the same default IP address. You must
Note:
change the IP address of the master P333R-LB switch in a stack in order to
guarantee that the stack has its own unique IP address in the network.
The network management station or a workstation running a Telnet client can establish
communications with the stack once this address had been assigned and the stack has been
inserted into the network. Use the CLI to assign the stack an IP address and net mask.
To assign an IP stack address:
1. Establish a serial connection by connecting a terminal to the master switch of the stack.
2. When prompted for a Login Name, enter the default name root
3. When you are prompted for a password, enter the password root. You are now in
Supervisor Level.
4. At the prompt, type:
set interface inband <vlan> <ip_address> <netmask>
Replace <vlan>, <ip_address> and <netmask> with the VLAN,
IP address, and net mask of the stack.
5. Press Enter to save the IP address and net mask.
24 Quick Start for Hardware Installation: P333R-LB Stackable Switch