Set Qos Policy-Source Command; Set Qos Dscp-Cos-Map Command - Avaya P334T-ML User Manual

Example:
Router-N(configure)# validate-group 101

set qos policy-source Command

Use the set qos policy-source command to set the policy source. The default
policy source is policy-server.
Note: Before configuring the IP access list, you must change the policy source mode
to local.
The syntax for this command is:
set qos policy-source <source>
<source>
Example:
Router-N(configure)# set qos policy-source local

set qos dscp-cos-map Command

Use the set qos dscp-cos-map command to configure the DSCP table.
The syntax for this command is:
set qos dscp-cos-map <dscp1>[-<dscp2>] <operation>
[<precedence>]
<dscp1>
<dscp2>
<operation>
<precedence>
Example:
Router-N(configure)#set qos dscp-cos-map 9-16 fwd3
P334T-ML User's Guide
- local | policy-server
- dscp range min (0-63)
- dscp range max (0-63)
- fwd0-7 | no-change
- mandatory | optional
Chapter 7 CLI – Layer 3
209