show internal buffering
The show internal buffering command displays the size options (Maximum,
Minimum, or Medium) of the Receive (Rx) buffer allocated to each port of the
specified switch.
The syntax for this command is:
show internal buffering [<mod_num>]
Output Example:
P330-N> show internal buffering 1
Module
------
1
Note: Internal buffering for the P330-ML switches will always have the value Not
supported. This command is used to display the internal buffering status for the
other P330 switches in the stack.
show boot bank
Use the show boot bank command to display the software bank from which the
switch will boot at the next boot process. This command should be issued separately
for each switch in the stack using the session command.
Note: If this command is to be implemented on a switch other than the stack master,
a session should be opened to the relevant switch.
The syntax for this command is:
show boot bank
Output Example:
show boot bank
Boot bank set to bank-a
Avaya P334T-ML User's Guidee
Internal Buffer
---------------
med
Chapter 6
CLI – Layer 2
71