User Wards; Auto Sets Wards; Auto Unset Wards; Customising Users - Menvier Security TS2500 Installation & Programming Manual

Appendices
Duress Code
This user type operates in the same way as a standard
global user, but when the passcode is used a silent
"Panic Alarm" is transmitted to the alarm receiving
+
centre.
If "Configuration option 02" is set to enabled, all
users can generate a "Duress" alarm by entering
their passcode with the first two digits reversed
(e.g. for a passcode of 2580 enter 5280 to
generate a "Duress" alarm).
Access
This user type does not have access to any user menus
nor can it be used to set and unset the system. When this
user code is entered it will operate specific outputs
which in turn can be used to operate an electric door
strike or similar.
Shunt
This user type does not have access to any user menus
nor can it be used to set and unset the system. When this
user code is entered it will isolate a pre-defined group of
detection circuits. When the code is re-entered it will
reinstate the group.
Set Only
This user type operates in the same way as a standard
global user, except that it only allows setting of wards.
Not in use
This user type does not perform any operation. Select
this user type to delete an existing user.

User Wards

Each user must be assigned to wards. Once assigned to
wards the user can then set, unset and reset the wards
they have been given access to.

Auto Sets wards

Wards that are assigned as auto set will automatically
be selected for setting when choosing the "SET WARDS"
option. If a ward is not assigned as auto set the user is
given the choice to select the ward at the time of
setting.

Auto Unset Wards

Wards that are assigned as auto unset will automatically
be selected for unsetting when choosing the "UNSET
WARDS" option. If a ward is not assigned as auto unset
the user is given the choice to select the ward at the
time of unsetting.
86

Customising Users

Access to user menus is initially defined by the user type,
e.g. the manager user has access to user menus 1 and
2, and a standard global user has access to user menu
1 only. However, each user can be customised so that
individual options within user menus are available or
restricted, e.g. user 002 could be given the initial type of
standard ward, then customised to allow the user to
access all user menus and options.
The table below shows all four user menus and the
options available:
User Menu User Menu
Key
1 2
1 Bell Test View circuits
2 Walk Test Set System
Time
3 Remote Set System
Reset date
4 Change Setup new
passcode users
5 Enable Chime
Chime Circuits
6 24hr Omit 24hr Group
7 Omit Zones Print System
Log
8 Silent Set Alter Wards
9 View System
Log
0 Set/Unset Rem. Serv.
Options
A Start Call
Back
B
C Set BST/GMT
Dates
TS2500 Installation Manual
User Menu User Menu
3 4
Time Auto-set
Switches Timers
Part Set
Groups
Use On-line
Pad
Edit User
Names
Part Set Text Log Search
Keys
Circuit Text Shunt
Groups
Set Volume
Level
Edit Quick
Keys
Activity Code Lock
Count Times