Remote Keypads; Netlcd Remote Keypad; Netstar Remote Keypad; Netled Remote Keypad - Menvier Security TS2500 Installation & Programming Manual

TS2500 Installation Manual

Remote Keypads

Four types of remote keypads are available:

NETLCD Remote Keypad

The NETLCD remote keypad has a 32 character back-lit
Liquid Crystal Display (LCD). The system must have at
least one NETLCD remote keypad fitted in order for
system programming to be carried out.

NETSTAR Remote Keypad

The NETSTAR remote keypad has a 8 character back-lit
+
starburst Liquid Crystal Display (LCD).
The NETSTAR remote keypad is limited to setting,
unsetting and part-setting, and cannot be used
for system programming. The display will always
show the system time.

NETLED Remote Keypad

The NETLED remote keypad has a 4 character LED
+
display.
The NETLED remote keypad is limited to setting,
unsetting and part-setting, and cannot be used
for system programming. The display will always
show the system time.

NETARM Remote Arming Station

The NETARM remote arming station only has two
indicator LED's, a power LED and a programmable
+
function LED which follows the programmable output.
The NETARM remote arming station is limited to
setting, unsetting and part-setting, and cannot
be used for system programming.
PCB Layouts & Connections
Œ
Detection Circuits.
Each remote keypad has two programmable
detection circuits.

Loudspeaker Volume.
For adjusting the volume of a speaker wired to the
remote keypad (NETLCD only).
Ž
LED Mimic.
If this jumper link is set to the "enabled" position,
the red (‹) LED on the keypad will be "ON" when
the keypad output is active.

Remote I/D.
Used to select the remote keypads address. (ENG
= Engineer).

Ward Sounder Control.
If this jumper link is set to the "disabled" position,
the remote keypad sounder will follow the control
panel speaker output. If this link is set to "enabled",
the remote keypad sounder will only activate
when the panel speaker and the output on the
remote keypad are active at the same time.
‘
Loudspeaker Output.
This terminal can be connected to a single 16 Ω
Loudspeaker (NETLCD only).
’
Network Connections & O/P.
Terminals A to E are used to connect the remote
keypad to the control panel network. The O/P
terminal is the programmable output.
“
Tamper Switch.
Remote Keypad case tamper
”
ENT Key Disable.
If the "ENT" key is enabled the remote keypad can
be used to set/unset and access all user menus. If
the "ENT" key is disabled the remote keypad can
only be used to set and unset the system.
1
Display Module
ENT KEY
DISABLED
9
Figure 12. NETLCD, NETLED & NETARM PCB Layout
3 1
LED MIMIC
Display Module
ENT KEY
DISABLED
9
Figure 13. NETSTAR PCB Layout
System Installation
2
LED MIMIC
3
I/D 1
2
4
3
Selector
4
ENG
REMOTE
I/D
5
A B C D E
-
O/P SPK
+
8 7 6
1
I/D
2
4
3
Selector
4
ENG
REMOTE
I/D
5
A B C D E
-
O/P
8 7
19