System Installation; Ts2500 Control Panel; Installation Procedure - Menvier Security TS2500 Installation & Programming Manual

System Installation

System Installation

TS2500 Control Panel

Installation Procedure

1. Open the control panel by removing three screws
from the front cover. Remove the cover and
disconnect the earth bonding cable from the
spade connection on on the transformer.
2. Note the position of the cable entries as follows:
(a) Ten 20mm cable entries for detection, alarm
and remote keypad cables.
(b) A 20mm cable entry for mains (230V) below the
+
mains input terminal block.
The mains cable must enter the control
panel through its own cable entry and must
not be mixed with other cables.
3. Hold the control panel back box in the required
position and mark the centre of the middle fixing
position. Remove the back box, drill and plug the
hole.
4. Screw a No 10 screw into the plugged hole.
Re-position the back box and mark the remaining
two securing holes. Remove the back box, drill and
plug the holes.
Fused Terminal
Block 200mA
Printed Circuit Board (PCB)
14
5. Re-position the back box and pass all cables into
the base via the appropriate cable entries,
remembering to fit grommeyts where necessary.
6. Secure the back box using not less than 30mm x No
10 screws through the three securing holes.
7. If required install and connect the following:
(a)
(b)
(c)
(d)
(e)
+
Figure 8. TS2500 Control Panel Layout
TS2500 Installation Manual
Stand alone digicom or RedCARE STU or other
signalling device.
Plug-on digicom type DC54, DC58 or DC58M.
Output modules type CPA6.OM.
Printer type DATAC or serial RS232 via a printer
adaptor (DCI/MPA).
Relay module type RM3A.
When replacing the cover, always ensure that
the earth bonding lead is connected to the
spade connection on the transformer.
Mains
Transformer
Spade connection
for earth lead to
front cover
Mains Cable
Entry
Battery
Position