Custom Circuits - Menvier Security TS2500 Installation & Programming Manual

Engineers Menu 3
1
=CIRCUIT
Select output
Type :- CIRCUIT
[
Select CCT type
0001 Mimic
1 = Mimic
2 = Alarm
3 = Tamper
4 = Test Fail
5 = Omit
[ To accept
Select cct no.
0001 Mimic
Enter Circuit No.
[ To accept

Custom Circuits

This option allows the engineer to program the eight
custom circuit types. Each custom circuit can be
programmed to activate the following:
Bell required
A custom circuit with the "Bell required" attribute will
activate the control panel bell and strobe output, and
any outputs programmed as "System Bell-SAB", "System
Strobe". The relevant "Ward Bell-SAB" and "Ward Strobe"
are also activated.
72
Engineers menu 3
A
Custom outputs
[
[ENT] to edit :-
Custom o/p 1,x
Press 1 8 - to select
the custom output
[ to edit
Custom o/p 3,1
0001 Alarm
Press 1 8 - to select
the switch number
[ to edit output type
Select output
Type :- CIRCUIT
2
=SYSTEM
Select output
Type :- SYSTEM
[
System type >04
Walk Test
Enter Output No.
or A C / to Scroll
[ To accept
Custom Outputs Flowchart
[3-B] Digi required
A custom circuit with the "Digi required" attribute will
activate any outputs programmed as "System Alarm"
and any relevant "Ward Alarm" outputs.
Sounder required
A custom circuit with the "Sounder required" attribute will
activate internal sounders assigned to the same ward
as the custom circuit.
Warning required
A custom circuit with the "Warning required" attribute will
generate a warning tone every minute from the internal
sounder assigned to the same ward as the custom
circuit.
3
=USER
Select output
Type :- USER
[
Enter user no.
001 Code entered
Enter User No.
or A C / to Scroll
[ To accept
TS2500 Installation Manual
4
=WARD
Select output
Type :- WARD
[
Select WARD Req.
Ward A Strobe
Enter Ward No.
1 9 - = Wards A-I
A C / to Scroll I-P
[ To accept
Ward type >01
Ward A Strobe
Enter Output No.
[
To accept