Installing A Remote Keypad On The Xnode; Installing A Keypad On To The Network; Xnode - Menvier Security TS2500 Installation & Programming Manual

System Installation

Installing a Remote Keypad on the XNode

1. Separate the cover and base by using a flat blade
screwdriver to gently prise the two halves apart.
Then lift the cover assembly away from the base,
noting that the PCB is connected to the under side
of the cover.
2. Hold the base in position (keyhole to the top) and
mark the appropriate securing holes, drill and plug
the wall as required. Pass all cables into the base via
the cable entry points as appropriate and secure
the base to the wall.
3. Connect the network cables to the appropriate
terminals.
4. Set the I/D jumper link to the required position, see
table below, ensuring no two remote keypads on
the same Node have the same I/D.
5. Set the "Remote Zone Enable" switch on the XNode
to enable zones in the remote keypads as required.
6. If installing the NETSTAR, NETLED or NETARM it is
recommended that the "ENT Key Disable" jumper is
set to the disabled position. This will ensure that the
keypad functions are limited to setting and
unsetting.
7. Finally clip the remote keypad cover onto the base
being careful not to trap any cables or to obstruct
the tamper switch.
Remote Keypads connected to XNodes
I/D Circuit A
1 Node Circuit A Node Circuit B
2 Node Circuit C Node Circuit D
3 Node Circuit E Node Circuit F
4 Node Circuit G Node Circuit H
ENG N/A
20
Circuit B Output
Node Output A
Node Output B
Node Output A
Node Output B
N/A N/A

Installing a Keypad on to the Network

1. Separate the cover and base by using a flat blade
screwdriver to gently prise the two halves apart.
Then lift the cover assembly away from the base,
noting that the PCB is connected to the under side
of the cover.
2. Hold the base in position (keyhole to the top) and
mark the appropriate securing holes, drill and plug
the wall as required. Pass all cables into the base via
the cable entry points as appropriate and secure
the base to the wall.
3. Connect the cables to the appropriate terminals.
4. Set the I/D selector jumper link to the required
position, see table below, ensuring no two remote
keypads, LECs or nodes have the same I/D.
5. Finally clip the remote keypad cover onto the base
being careful not to trap any cables or to obstruct
the tamper switch.
Remote Keypads connected to the Network
I/D Circuit A
1 N001
2 N009
3 N017
4 N025
ENG N033
N = Network Number (1 - 8)

XNode

The XNode is very similar to that of TS900 Node in that it
pro vi d e s t he f ac i l i t y t o ad d a n e x tr a e ig h t
pro gr a m m ab l e d e te c t i on c i r c ui t s a nd t w o
programmable outputs. However, the XNode can also
drive extension loudspeakers, up to 4 remote keypads
and an output module. The maximum number of
XNodes that can be connected to any one network is
16.
TS2500 Installation Manual
Circuit B Output
N002 N01A
N010 N02A
N018 N03A
N026 N04A
N034 N05A