Digi Baud Rate; Com1 Baud Rate; Internal Digi; Reset Digicom - Menvier Security TS2500 Installation & Programming Manual
1040 zone intruder alarm control system
Hide thumbs
Also See for TS2500:
- Installation & programming manual (100 pages) ,
- Operator's manual (48 pages) ,
- Quick manual (8 pages)
Table of Contents
Advertisement
Engineers Menu 3
Digi Baud rate
This option allows the engineer to set the baud rate for
the plug-on digicom. For the DC54/58/58M this MUST be
set at 300 baud.
COM1 Baud rate
This option allows the engineer to set the baud rate for
the general communication port (For future use).
7
[ENT] to edit :-
Digi BAUD rate
[ENT] to edit :-
8
COM1 BAUD rate
DC58(M)BAUD rate
Select rate by pressing:
1 = 300
2
= 600
3
= 1200
4
= 2400
Digi & Com1 Bauld Rate Flowchart
Internal digi
This option allows the engineer to use the DC58/58M as
a multi account digicom. This in effect gives you 16
digicoms in one unit. The feature can only be used with
DC58/DC58M's fitted with version 2.8 software.
Each channel can be assigned a ward output type,
e.g. channel 3 ward alarm. Each ward can then be
assigned a four digit account number (if the ward
account is set to '0000' then all channels for that ward
are disabled).
Reset Digicom
This option resets the plug-on digicom and uploads the
digicom NVM data to the control panel. The upload will
take approximately 25 - 30 seconds. Once uploaded
the data can be edited using the "Program Digicom"
option and then sent back to the digicom.
[ENT] to
0
Reset DigiCom
Acceptance tone indicates
reset performed
Reset Digicom Flowchart
76
[ to edit
Baud rate
300
5
= 4800
6
= 9600
7
= 19200
8
= 38400
[
[
[ENT] to edit :-
9
Internal digi
Ward channel 1
is 07
[ to edit ward type
Ward channel 1
is 07 > Fire Alm.
A C
/
to scroll ward types
[
Ward channel 1
is 07
A C
/
to scroll channels 1-8
and account No.
Account No. for
ward A is
[ to edit account No.
Account No. for
ward A is >0000
Enter account No.
[
Internal Digicom Flowchart
Activity Count
Circuits with the "Activity Monitor" attribute that have
been activated whilst the system was unset cause the
"Activity Counter" to be increased by one. This option
allows the engineer to view the counter value.
Engineers menu 3
0
Activity Count
Ward A activity:
A = Next ward
C = Previous ward
B = Reset counter
Ward P activity:
Activity Count Flowchart
TS2500 Installation Manual
[ to edit
Channel No.
Ward Type
Fire Alm.
to accept
Fire Alm.
0000
to accept
[3-0]
[
0000
Activity count
0000
]
Advertisement
Table of Contents
