Menvier Security TS2500 Installation & Programming Manual page 63

TS2500 Installation Manual
Event
PHONE LINE FAULT Telephone line fault detected
QUICK SET KEY # Quick set key A, B or C activated
Q.SET ABORTED Quick set key aborted
REARM ON WARDS:- Wards:- A - P re-armed
REINSTATED WARDS Wards A - P reinstated
REM #,## TAMPER Remote keypad lid tamper
REM RESET ACTIVE Remote reset via the REM RESET input terminal (RedCARE)
REM RESET FAILED Remote Reset failed
REM SERVICE CALL Remote service call in progress
RESET WARDS:- User or engineer has reset wards:- A - P
SEC. KEY #### Security key operated on circuit number ####
SERVICE CALL END Remote service finished
SERVICE REQUIRED System requires a service visit (Service Timer expired)
SET FAIL WARDS:- Set fail for wards:- A - P
SET FAIL #### Set fail caused by circuit ####
SET NO ACTIVITY System was set with inactive circuits (circuits with the activity attribute)
SET WARDS:- Wards set:- A - P
SET WITH L.FLT:- Wards A - P set with a line fault present
SETTING DEFERRED Setting deferred
SHUNT CODE ### Shunt code number ### enter their passcode
SHUNT KEY #### Shunt key circuit #### operated
SYSTEM RELEARN A system relearn has been performed
T.SWITCH # OFF Time switch number # off
T.SWITCH # ON Time switch number # on
TAMPER #### Tamper alarm from circuit number ####
TAMPER WARDS:- Tamper alarm on wards:- A - P
TEST FAIL #### Circuit number #### failed whist on test
TEST TOTAL #### Total number of circuit tested during walk test
TIME CHANGED System time changed
UNSET WARDS:- Wards:- A - P unset
USER ### DELETED User number ### deleted
WALK TESTED:- Wards:- A -P walk tested
WARD KEY #### Ward key circuit #### operated
WARDS LOCKED:- Wards:- A - P locked via security key circuit
WARDS UNLOCKED:- Wards:- A - P unlocked via security key circuit
XNODE #,## FUSE XNode fuse failed
XNODE #,## TAMP XNode lid tamper
Description
Engineer's Menu 2
59