Introduction; Control Panel; Remote Keypads; Character Lcd (Netlcd) - Menvier Security TS2500 Installation & Programming Manual

TS2500 Installation Manual

Introduction

The TS2500 intruder alarm control system has been
designed to suit medium to large installation sites. The
TS2500 system can be expanded up to 1040 zones. The
system is capable of "up" and "down" line loading,
allowing remote programming and interrogation via
the telephone line and a P.C.
Complex site requirements such as multi-ward setting
can be achieved, as the system is capable of being
broken down into 16 separately controlled areas
(Wards) so that the premises or parts of the premises can
be controlled independently.
The TS2500 system is a true multi-tasking system, which
allows up to maximum of eight users operating the
system simultaneously.

Control Panel

The control panel is the controlling unit for the system, it
has a power supply and connections for a standby
battery. It has the following facilities:
8 networks for connecting remote keypads and
l
Nodes
Connections for two 8 zone local expansion cards
l
(TSLEC8)
Two auxiliary tamper zones
l
Bell and strobe outputs
l
4 programmable outputs (1 x Voltage free
l
contacts and 3 high current transistorised)
8 programmable digicom/RedCARE outputs
l
A connector for a Menvier plug-on digicom or
l
digi-modem
A connector for a printer via the MPA or DCI printer
l
adaptor
A connector for mimic modules (CPA6.OM)
l
Extension loudspeaker output
l
All system program information and the 4000 event
l
log is stored in two removable non-volatile memory
(NVM) devices
2

Remote Keypads

Up to 5 remote keypads can be connected when
directly wired to the network. The XNode also provides
the facility to connect up to 4 remote keypads giving a
system total of 512 remote keypads. Each remote
keypad has two detection circuits and a single switched
-ve output. The four types are:

32 Character LCD (NETLCD)

The NETLCD remote keypad has a back-lit 32 character
super-twist Liquid Crystal Display (LCD) and a back-lit
tactile rubber keypad. All system programming must be
carried out from a NETLCD remote keypad.

8 Character Starburst (NETSTAR)

The NETSTAR remote keypad has a back-lit 8 character
starburst display (LCD) and a back-lit tactile rubber
keypad. This type of remote keypad is limited to setting
and unsetting only, and cannot be used to program the
+
system.
The display will always show the system time.

4 Character LED (NETLED)

The NETLED remote keypad has a 4 character
7-segment LED display and back-lit tactile rubber
keypad. This type of remote keypad is limited to setting
and unsetting, and cannot be used to program the
+
system.
The display will always show the system time.

Remote Arming Station (NETARM)

The Remote Arming Station only allows setting and
unsetting of the system. The unit has two indicator LED's,
the "Power LED" and a programmable "Function LED"
(the "Function LED" may be programmed as "Fault" or
"Area Set" etc.).

Expansion Devices

There are several options for expanding the system:

TS700 LEC

The Local Expansion Card (LEC) provides two
pro gr a m m ab l e d e te c t i o n ci rc ui t s an d on e
programmable switched -ve output. Up to 5 TS700 LECs
can be connected on any one network.

TS900 Node

The TS900 Node provides eight programmable
detection circuits and two programmable outputs (one
switched +ve and one switched -ve). Up to 5 TS900
Nodes can be connected on any one network.
System Overview