Unpacking The Switch; Unpacking An Ex4300 Switch; Chapter 10 Unpacking The Switch - Juniper EX4300 Hardware Manual

CHAPTER 10

Unpacking the Switch

Unpacking an EX4300 Switch

Related
Documentation
Copyright © 2017, Juniper Networks, Inc.
Unpacking an EX4300 Switch on page 161
Parts Inventory (Packing List) for an EX4300 Switch on page 162
Registering Products—Mandatory for Validating SLAs on page 163
EX4300 switches are shipped in a cardboard carton, secured with foam packing material.
The carton has an accessory compartment and contains the quick start instructions.
CAUTION: EX4300 switches are maximally protected inside the shipping
carton. Do not unpack the switches until you are ready to begin installation.
To unpack the switch:
Move the shipping carton to a staging area as close to the installation site as possible,
1.
but where you have enough room to remove the system components.
Position the carton so that the arrows are pointing up.
2.
Open the top flaps on the shipping carton.
3.
Pull out the packing material holding the switch in place.
4.
Verify the parts received against the inventory on the label attached to the carton.
5.
See "Parts Inventory (Packing List) for an EX4300 Switch" on page
Save the shipping carton and packing materials in case you need to move or ship the
6.
switch later.
Installing and Connecting an EX4300 Switch on page 165
Connecting and Configuring an EX Series Switch (CLI Procedure) on page 215
Connecting and Configuring an EX Series Switch (J-Web Procedure) on page 218
162.
161