Line To Line Port Re-Assignment - Comdial DSU II System Manual

DSU II Digital Telephone System
3.6.7

Line To Line Port Re-Assignment

Description: You can reassign the programming attributes for a line that the installer has connected to
a particular line port to a different line port with this programming action. This feature
allows you to automatically exchange all software attributes for one line with those
assigned to another at a different line port without physically re-locating the lines or
reprogramming any of the attributes.
To Program: 1. Dial 41.
2. Select currently assigned line port number.
3. Dial new line port number (01–24 = line 1–24). "LOGICAL LINE XX"
4. Dial
5. Repeat steps 2–4 for another assignment
To change setting, repeat procedure and make different selection or make same port
selections in both steps 2 and 3 to match logical to physical assignment.
—Line port 1–14 = Dial 01–14 or Press A1–A14.
—Line port 15, 16 = Dial 15, 16 or press B1, B2.
—Line port 17–24 = Dial 17– 24 or press HOLD then press A1–A8.
#
to make assignment.
—OR—
dial for configuration mode.
"ASSIGN LOGICAL/PHYS "
"PHYS LATCH XX"
Programming The DSU II System 3 – 41
IMI66–132