Data Printer Service; Enable Data Printer Operation - Comdial DSU II System Manual

DSU II Digital Telephone System
3.13

Data Printer Service

When you connect a data printer to the system, the system automatically prints the station message detail
record (SMDR) for the entire system without any programming or user intervention.
You call also command the data printer to print partial or complete printouts of the configuration data for
the system. While you are using the printer to print the configuration data or SMDA information, the
system temporarily halts the SMDR printout although it continues to collect the SMDR data. You should
note, however, that if it logs more than two calls for any one line, call records may be lost.
NOTE: A lighted LED next to the programming button for the selection indicates the current
configuration. When a single button provides a toggle (on/off) action, the lighted LED
indicates the active feature.
The first step in any programming sequence is to enter the base level. Once in this mode, you can dial the
feature code for any desired configuration. Enter the base level with the following procedure:
press INTERCOM then dial # 7 4 6 . When you want to end the programming, press the SPEAKER
button to end the programming procedure and return the system to normal operation.
3.13.1

Enable Data Printer Operation

To Program: 1. Dial 91.
2. Choose configuration
3. Dial
—Dial 1 to print all configuration data
—Dial 2 to print system data
—Dial 3 to print line data
—Dial 4 to print data for all stations
—Dial 5 to print data for selected station
—Select station to be printed
—Dial 10–57 for stations 10–57
—Dial 6 to print toll restriction assignment
—Dial 7 to abort printing.
for configuration mode.
"PRINT CONFIG."
"PRINT ALL"
"PRINT SYSTEM "
"PRINT LINES"
"PRINT STATIONS"
"PRINT STA."
"PRINT STA. XXX"
"PRINT TOLL"
"ABORT PRINT"
Programming The DSU II System 3 – 103
IMI66–132