Programming For Dcd Operation; Dcd Department Transfers Before Disconnect - Comdial DSU II System Manual

DSU II Digital Telephone System
3.21.1

Programming For DCD Operation

Description: When you plan to enhance DCD operation with the DVA, you must first completely
program the system for DCD operation.
To Program: To enable the system for DCD operation, refer to the instructions in section 3.11, Direct
Department Calling and complete the following steps:
1. Assign direct department dialing access code (often referred to as a department pilot
2. Assign direct department calling line ports.
3. Assign direct department calling station ports.
4. Refer to the instructions in section 3.7.6, Call Forward On Busy/Ring No-Answer,
5. Use the procedure described immediately below, and program the DCD department
3.21.2

DCD Department Transfers Before Disconnect

Description: Because the system will continue transferring a call back to a department after a recall to
DVA time-out has occurred, you can set the number of transfer times that occur before
the system drops the call.
To Program: 1. Dial 17.
2. Dial 10.
3. Choose 1–9 transfer times or set system to always transfer.
4. Press
To change setting, repeat procedure and make different selection.
number).
and program the department stations to have ring no-answer call forwarding.
transfers before disconnect.
(LED On = Enabled)
—Dial 1 or press A1
—Dial 2 or press A2
—Dial 3 or press A3
—Dial 4 or press A4
—Dial 5 or press A5
—Dial 6 or press A8
—Dial 7 or press A9
—Dial 8 or press A10
—Dial 9 or press A11
—Dial 0 or press A12
for configuration mode.
"SYSTEM FEATURES"
"DEPT XFR X"
"DEPT XFR 1"
"DEPT XFR 2"
"DEPT XFR 3"
"DEPT XFR 4"
"DEPT XFR 5"
"DEPT XFR 6"
"DEPT XFR 7"
"DEPT XFR 8"
"DEPT XFR 9"
"NEVER DISCONNECT"
Programming The DSU II System 3 – 155
IMI66–132