Enabling The Tracker Paging System; Enabling The Tracker Pagers For Stations - Comdial DSU II System Manual

IMI66–132
3.20.1

Enabling The Tracker Paging System

Description: Use this procedure to enable the Tracker Paging System feature as a system-wide feature.
To Program: 1. Dial 17.
2. Dial 06.
3. Press A1 to toggle between enable or disable (LED On = Enabled)
4. Press
To change setting, repeat procedure and make opposite selection.
3.20.2 Enabling Tracker Pagers For Stations
Description: After you have enabled the Tracker Paging System as a system-wide feature, enable the
Tracker pagers at individual stations. Station users can disable a Tracker Pager by
pressing INTERCOM #06 or enable a Pager by pressing INTERCOM 06.
To Program: 1. Dial 53.
2. Dial 37.
3. Enable Tracker pager operation
4. Press
To clear current setting, repeat procedure.
NOTE: The Pager's ID must be programmed to correspond to a DSU station
3 – 152 Programming The DSU II System
—OR—
dial 1 to Enable (A1 LED On)
dial 2 to Disable.
for configuration mode.
—Dial 10–57 or press C10–C57 (LED On = Enabled).
for configuration mode.
number. Pager programming must be done through the Tracker base station.
Refer to the "Program Mode" section of IMI89–138, Operating Instructions
For The Tracker Paging System.
DSU II Digital Telephone System
"SYSTEM FEATURES"
"TRACKER XXXXXX"
"TRACKER ENABLED"
"TRACKER DISABLED"
"STATION FEATURES"
"DISPLAY PAGER"