Data Baud Rate - Comdial DSU II System Manual

DSU II Digital Telephone System
3.4.2

Data Baud Rate

Description: The speed or baud rate of the data bit stream, which carries the SMDR and configuration
data between the system and an external data device, must be programmed to match the
requirements of the data device.
NOTE:
To Program: 1. Dial 15.
2. Dial code for serial data port to be programmed:
3. Choose baud rate
4. Dial
5. Dial
To change setting, repeat procedure and make opposite selection.
If you use XMODEM protocol for data transfer between a PC and the
common equipment, you must use 8-bit data.
Dial 1 for COM 1,
Dial 2 for COM 2,
Dial 3 for COM 3,
Dial 4 for COM 4.
—Dial 01 or Press A1
—Dial 02 or Press A2
—Dial 03 or Press A3
—Dial 04 or Press A4
—Dial 05 or Press A5
—Dial 06 or Press A8
—Dial 07 or Press A9
—Dial 08 or Press A10
—Dial 09 or Press A11
—Dial 10 or Press A7 for 7 data bits
and 2 stop bits
—Dial 11 or Press A14 for 8 data bits
and 1 stop bit.
for next data port.
for configuration mode.
"BAUD RATE"
"W nD nS 110"
"W nD nS 150"
"W nD nS 300 "
"W nD nS 600"
"W nD nS 1200"
"W nD nS 2400"
"W nD nS 4800"
"W nD nS 9600"
"W nD nS 19200"
"W 7D 2S ZZZZZ"
"W 8D 1S ZZZZZ"
Programming The DSU II System 3 – 17
IMI66–132