Defaulting The Stations; Defaulting The Button Assignments; Defaulting The Toll Restriction Tables - Comdial DSU II System Manual

DSU II Digital Telephone System
3.3.4

Defaulting The Stations

Description: Returns the station configuration features to factory settings.
To Program: 1. Press INTERCOM, dial
2. Dial 50.
3. Dial 00 to default station ports system-wide
4. Dial
3.3.5

Defaulting The Button Assignments

Description: Returns the button mapping of individual stations to its factory setting.
To Program: 1. Press INTERCOM, dial
2. Dial 56.
3. Dial 01.
4. Select station ports to be defaulted
5. Dial
3.3.6

Defaulting The Toll Restriction Tables

Description: The system defaults two toll restriction tables with preprogrammed values and assigns
them to the lines. You need only to assign them the stations to put them into effect. The
preprogrammed values are as follows:
Table 1 (deny)
Entry 1 = 1
Entry 2 = 976
Entry 3 = 411
Entry 4 = 0
These values will provide satisfactory system performance in a broad range of site
applications; however, they can be changed as needed to meet different toll restriction
needs.
To Program: 1. Dial 70
2. Press # to default toll tables
3. Dial
—OR—
select individual station port to be defaulted:
— Station 10–57 = Dial 10–57.
for next station to default
—OR—
dial for configuration mode or SPEAKER to quit.
—Station 10–57 = Dial 10– 57.
for next button mapping feature
—OR—
dial for configuration mode or SPEAKER to quit.
for configuration mode or SPEAKER to quit.
# 7 4 6 . "CONFIG. MODE"
"STATION DEFAULT"
# 7 4 6 . "CONFIG. MODE"
"BUTTON MAPPING"
"BUTTON DEFAULT"
Table 2 (allow)
Entry 1= 1800
Entry 2 = 911
"DEFAULT TOLL"
Programming The DSU II System 3 – 13
IMI66–132