Block Programming - Comdial DSU II System Manual

DSU II Digital Telephone System
3.6.9

Block Programming

Description: You can use this configuration procedure to assign those features that you have assigned
to any one line (using the procedures detailed on the previous pages) to any other line or
to an entire block of lines.
To Program: Line Button Method
1. Dial 42.
2. Select model line port.
3. Select lines to match model line (as detailed above).
4. Dial
Keypad Method
1. Dial 42.
2. Select model line port
3. Dial first line port in block (dial 01–24).
4. Dial #.
5. Dial last line port in block (dial 01–24).
6. Dial #.
7. Dial
NOTE:
The first, last, and all line ports in between will be block programmed like the model line port.
To block program an individual line port, select the first line port and last line port to be the
same number. For example: 01, 02#, 02# programs line 02 the same as line port 01 is
prgrammed.
Line port 1–14 = Press A1–A14
Line port 15, 16 = Press B1, B2
Line port 17–24 = Press HOLD then press A1–A8.
and repeat steps 2 and 3 for next model line.
—OR—
Dial for configuration mode.
Line port 1– 24 = Dial 01–24.
for next model line.
— OR—
Dial for configuration mode.
"BLK PROGRAMMING"
"MODEL LINE XX"
"BLK PROGRAMMING"
"MODEL LINE XX"
Programming The DSU II System 3 – 43
IMI66–132