Audible Monitoring - Comdial DSU II System Manual

DSU II Digital Telephone System
3.7.3

Audible Monitoring

The DSS/BLF at a multiline station provides a visual indication of idle, busy, and ringing status of the
monitored stations. You can also provide audible indication of direct and delayed ringing for selected
stations; however, you must first enable the station monitoring feature on a system-wide basis.
Enable Audible Monitoring
Description: Enable audible monitoring on a system-wide basis using this feature.
To Program 1. Dial 20.
2. Press A1 to switch between enable and disable (LED On = Enable)
3. Dial
To change setting, repeat procedure and make opposite selection.
Assign Audible Monitoring To Stations
Description: Once you have enabled audible monitoring system wide, you must select each station and
the type of audible monitoring that you want to program.
To Program: 1. Dial 53.
2. Dial 20.
3. Select monitoring type.
4. Select stations ports (LED On = Feature Assigned)
5. Dial
To change setting, repeat procedure and make different selection.
—OR—
dial 1 to Enable
dial 2 to Disable.
for configuration mode.
—Dial 1 for no audible monitoring
—Dial 2 for direct ring monitoring
— Dial 3 for delayed ring monitoring.
—Station 10–57: Dial 10–57 or press C10–C57.
next monitoring condition
—OR—
dial for next station feature
—OR—
dial for configuration mode.
"MONITOR XXXXXXX"
"MONITOR ENABLED"
"MONITOR DISABLED"
"STATION FEATURES"
"AUDIBLE MONITOR "
"NONE"
"DIRECT RING"
"DELAYED RING "
Programming The DSU II System 3 – 49
IMI66–132