Call Forward On Ring-No Answer - Comdial DSU II System Manual

DSU II Digital Telephone System
3.11.5 Call Forward on Ring—No Answer
The system can automatically forward ring-no answer calls to a new station. The system sends these calls
to any idle station associated by department with the called station. Use this feature to arrange for calls to
cycle rapidly through such associated stations by testing each one in turn with several rings.
Call Forwarding Of RNA Calls
Description: Enable call forward of RNA calls for individual stations using this programming feature.
NOTE: If you enable this feature, also program the system intercom signaling as
To Program: 1. Dial 53.
2. Dial 21.
3. Dial 0–9 for 0–9 rings before forwarding.
4. Select station ports (LED On = Feature Assigned)
5. Dial
To remove call forwarding from a station, assign 0 rings.
Set Tone First Intercom Signaling
Description: You must set the first choice intercom signaling method to tone first to ensure forwarding
of calls that encounter a busy signal or ring with no answer.
To Program: 1. Dial 16.
2. Press A1 to toggle from Voice To Tone (LED Off = Tone)
3. Dial
To change setting, repeat procedure and make opposite selection.
tone for the first choice.
—Station 10–57: Dial 10–57 or press C10–C57.
for for additional station ring assignments,
—OR—
dial for next station feature,
—OR—
dial for configuration mode.
—OR—
dial 2 for Tone First.
for configuration mode.
"STATION FEATURES"
"CALL FWD RNA "
"RING S= X"
"XXXXX ANN. FIRST"
"TONE ANN. FIRST"
Programming The DSU II System 3 – 99
IMI66–132