Account Codes; Account Code Length - Comdial DSU II System Manual

IMI66–132
3.9

Account Codes

The digital telephone system uses account codes to identify calls by category, or by any other desired
grouping, so that it can record the cost of the calls by that category or grouping. The account code can be
either verified or not verified by the system; plus, the system can either force the users to use the account
codes or make their use of it optional. When you enable account code verification, the system compares
the account code entered by a station user with the account entries that you have programmed. If the
system does not find a match and the account code entry is optional, the system sounds an error tone
through the telephone but does not prevent dialing; however, if forced entry is enabled, the system
prevents further dialing until the user enters a matching account code.
You should make a record in Chapter 4 of all programming decisions that you make—it will help you
keep track of what you have done and will help you troubleshoot any problem that might arise later.
NOTE: A lighted LED next to the programming button for the selection indicates the current
configuration. When a single button provides a toggle (on/off) action, the lighted LED
indicates the active feature.
The first step in any programming sequence is to enter the base level. Once in this mode, you can dial the
feature code for any desired configuration. Enter the base level with the following procedure:
press INTERCOM then dial # 7 4 6 . When you want to end the programming, press the SPEAKER
button to end the programming procedure and return the system to normal operation.
3.9.1

Account Code Length

Length For Verified Account Codes
Description:
This feature defines the number of digits that the system will verify before it accepts the account code as
valid. Verified account code length also defines the number of valid account codes that the system will
store (as shown in the following table). Be aware that when you change the verified account code length,
the system empties the current list of valid account codes.
To Program: To specify the number of verifiable account code digits,
1. Dial 75.
2. Dial 15.
3. Dial number of digits 3–16 to be verified.
4. Dial
To change setting, repeat procedure and make different selection.
3 – 86 Programming The DSU II System
Account Code Lengths
Digits Number Of
Verified Codes
3 1000
4 400
5, 6 266
7, 8 200
9, 10 160
11, 12 133
13, 14 114
15, 16 100
for configuration mode.
DSU II Digital Telephone System
"SMDA PROGRAMMING"
"DIGITS VALID X "