P_Rear Sensor Assy - Epson Stylus Pro 7600 Service Manual

EPSON Stylus Pro 7600/9600

4.4.6 P_REAR Sensor ASSY

1. Remove the R Side Cover. (p.160)
2. Remove the L Side Cover. (p.163)
3. Remove the I/H Cover. (p.164)
4. Remove the H Top Cover. (p.165)
5. Remove the Rear Cover. (p.166)
6. Disconnect the connector (CN27: black 4-pin) of the P_REAR Sensor ASSY from the
Main Board.
7. Push the Paper Hold Lever down to the front.
8. Remove the lower two screws (CBS: M4×6) securing the Paper Guide U.
(See Figure 4-60)
Remove the upper three screws (CBS: M4 × 6) (six screws for Stylus Pro 7600)
9.
securing the Paper Guide U and remove the Paper Guide U by pulling it up toward you
slowly.
When removing/installing the Paper Guide U, be careful not to mar
C A U T I O N
the P_REAR Sensor ASSY with the edge of the sensor inspection
window.
10. Remove the two (CP(W): M2×8) screws securing the P_REAR Sensor ASSY and
remove the P_REAR Sensor ASSY.
The P_REAR Sensor ASSY position is adjusted at the factory
C H E C K
before shipment. When the sensor bracket is to be removed on the
P O I N T
service site, you are advised to mark the mounting position before
removal for easy adjustment at reassembly.
If you replace the P_REAR Sensor ASSY, perform the necessary
A D J U S T M E N T
R E Q U I R E D adjustment.
Refer to "5.1.4.6 P_REAR Sensor ASSY Adjustment" (p.215)
Disassembly & Assembly
(See Figure 4-61)
Disassembly and Assembly of Paper Feed Mechanism
P_REAR Sensor ASSY peeping window
Figure 4-60. Removing the Paper Guide U
Screws (M2×8) ×2
P-REAR Sensor ASSY
Figure 4-61. Removing the P_REAR Sensor ASSY
Revision A
Screws (M4×6) ×5
Paper Guide U
191