No Margin Print Setting - Epson Stylus Pro 7600 Service Manual

EPSON Stylus Pro 7600/9600

1.4.3.11 No margin print setting

No margin print mode can be switched with these settings.
Following 3 modes can be selected;
Mode
Left/right no margin (default) Only right/left margin can be set to 0. Top/bottom margin is
set with roll paper margin setting.
4 sides no margin / 1 cut Left/right and top/bottom margin can be set to 0. Cutting
methods are following;
• After JOB is started, it cuts off the paper edge with the
minimum margin during printing.
• There is no margin between pages during JOB. It cuts off
paper on the border of image.
• After JOB is completed, it cuts off paper at the end of
image.
4 sides no margin / 2 cuts Left/right and top/bottom margin can be set to 0. Cutting
methods are following;
• After JOB is started, it cuts off the paper edge with the
minimum margin during printing.
• It cuts off paper at the end of image each page.
• It cuts off paper after paper feeding with the minimum
margin
*1. When 4 sides no margin / 2 cuts is selected, vertical length will be 2mm shorter than actual
print size after cutting.
*2. When roll paper cutter OFF and page line print ON, page line is printed for each cutting
position including page top cutting.
*3. We recommend 6cm for glossy paper, and 10cm for other papers.
Product Description
Table 1-31.
Operation
(*3) .
No margin setting
Right/left no margin
No margin mode
Printer operation
Driver setting No margin print
Panel setting NO MARGIN L/R
(Printer setting menu) ONLY
Notes Default
Operating Panel
Table 1-32.
4 sides no margin
No margin mode (1 cut)
No margin print
Auto cut
NO MARGIN
1 CUT
• Uneven coloring
may occur for some
image, because top
edge is cut with
print interruption.
• Continuous data
may be left slightly
on the top/bottom
because of cutter
position gap.
Revision A
4 sides no margin
(2 cuts)
No margin print
Auto cut
NO MARGIN
2 CUTS
• Uneven coloring
may occur for some
image, because top
edge is cut with
print interruption.
• The top/bottom is
cut inside of border
to prevent margin
from leaving on
paper. Vertical
length will be 2mm
shorter than actual
print size after
cutting.
43