Epson Stylus Pro 7600 Service Manual page 241

EPSON Stylus Pro 7600/9600
FEED CORRECTION + T&B ADJUSTMENT
1. Start the Self-diagnostic Function:
[Paper Feed ∆] [Paper Feed ∇
Power OFF →
+
2. Display "Adj: Feed Adj.+T&B":
[Paper Feed ∇] → [SelecType >] → [Paper Feed ∆] x6
3. Print the pattern.
[SelecType >] →[Enter ↵] when "[Enter] Adjust Print" is displayed
5-32)
4. Measure the top margin:
Using a measuring rule, measure the top margin. Input the measured value on the
panel.
5. Measure the bottom margin:
Using a measuring rule, measure the bottom margin. Input the measured value on the
panel.
6. Measure the side margin:
Using a measuring rule, measure the side margin. Input the measured value on the
panel.
7. Measure the feed correction value:
Using a measuring rule (1000 mm) and the scale stopper, measure the longitudinal line
length. Input the measured value on the panel.
The central print pattern among the patterns as shown above is
C H E C K
intended for use as a datum line on which the measuring rule is
P O I N T
to be placed.
Even if you have left the "Feed Correction + T&B Adjustment"
mode by mistake, you can restore the relevant adjustment
display without reprinting the pattern, by pressing [Paper
Source <] when "[Enter] Adjust Print" is displayed.
Adjustment
]+[Cut/Eject] → Power ON
(See Figure
Self-diagnostic Function
Bottom margin (14.0mm)
Top margin (3.0mm)
Figure 5-33. Print Pattern for Feed Correction + T&B Adjustment
Revision A
Side margin
(3.0mm)
241