Type-B I/F Error; Paper Cutting Error; Paper Not Straight - Epson Stylus Pro 7600 Service Manual

EPSON Stylus Pro 7600/9600

3.2.2.7 Type-B I/F error

Item
LCD PANEL
OPTION I/F ERROR
MESSAGE
LED STATUS None
A non-supported option Type-B I/F card is installed into the
printer.
Explanation
This error occurs when the printer is turned on.
Turn off the printer, remove the option Type-B I/F card, and then
turn on again.
Recovery
If the error recurs, repeat checking by installing another Type-B
interface.

3.2.2.8 Paper cutting error

Item
LCD PANEL
PAPER NOT CUT
MESSAGE
LED STATUS "PAPER OUT" LED is blinking.
The paper cannot cut whole paper completely by the cutter, or cut
Explanation
paper remains over the front paper sensor.
Remove the cut paper, or cut manually the paper using scissors
or else. User should lift the paper set lever and reset the paper or
push the Pause button. Thereby the printer will execute paper
initialize operation and will be printable status. In this time, if
the paper is so disarranged that it may cause head friction or
paper jam, user should cut the disarranged part neatly and reset
Recovery
the paper. User should replace the cutter blade if it becomes
dull.
Checking the operation of the Cutter Solenoid:
Execute
any problem is found, replace the actuator.
Troubleshooting
Table 3-11.
Description
Table 3-12.
Description
"Actuator 2 (p.229)" in the self-diagnostics menu and if

3.2.2.9 Paper Not Straight

Item
LCD PANEL
MESSAGE
LED STATUS
Explanation
Recovery
Error Display
Table 3-13.
Description
PAPER NOT STRAIGHT
"PAPER OUT" LED is blinking.
When a skew exceed 3mm between top and end of the paper is
occur, user should confirm the previous printout because it may
not be printed completely. And also smudges on back of following
printouts may occur because of poured ink on the platen.
This error is cleared by paper set operation.
• User should set the paper according the description of User's
guide exactly in order to prevent the occurrence of this error.
• The roll edge should be neatly arranged.
• This error can be prevented at following printing by paper set
operation.
This error may also cleared by turning OFF→ ON, but this error
may occur at following printing.
Revision A
128