EPSON Stylus Pro 7600/9600
4.7 Disassembly and Assembly of Circuit Boards
This section describes the procedures for removing the Power Supply Board, Main
Board (C472MAIN) and AC Inlet.
4.7.1 Power Supply Board
Unplug the AC power cable and wait at least five minutes before
C A U T I O N
removing the Power Supply Board to make sure there is no residual
power left in the board's capacitors.
1.
Remove the Rear Cover. (p.166)
2.
Disconnect the following connectors from the Power Supply Board:
Table 4-5. Connectors on Power Supply Board
Connector No.
Pins
Color
CN001
3
White
CN301
12
White
3.
Remove the eight screws (CPS: M4×8) securing the Power Supply Board, and then
remove the Power Supply Board.
Disassembly & Assembly
Connection
Notes
AC inlet
Lock type
C472MAIN
Lock type
Disassembly and Assembly of Circuit Boards
Screws (CPS: M4×8) ×8
CN301
Figure 4-80. Power Supply Board Removal
Revision A
CN001
205