Top & Bottom Adjustment - Epson Stylus Pro 7600 Service Manual

EPSON Stylus Pro 7600/9600
5.2.3.8 Top & Bottom Adjustment
Conduct printing and paper cutting and input the distances between the Front Sensor
and the Head, between the Cutter and the Head and between the Edge Sensor 0 and the
Head (printing start position) to adjust the top, bottom and side margins.
Press the [Pause] key on the compensation value input screen, and the display
will change to "Top and Button".
Press the [Enter} key on the input screen for "Top Length" or "Bottom
Length", and the display will change to the input screen for "Bottom Length"
or "Side Margin", respectively.
Press the [Enter] key on the input screen for "Side Margin", and the display
will change to "Rear Sensor Position".
Correction pattern of distances between the Front Sensor and the Head, between
the Cutter and the Head
Adjustment items:
Printing method:
Pattern drawing method: Printing direction:
Adjustment
Top margin (Front Sensor position)
Bottom margin (cutter position)
Side margin (printing start position)
Black 1 pass, Uni-D mode 180 dpi
Uni-D
Resolution: 360dpi
Printing speed: 240CPS
Dot: NormalDot2
Printing Pattern
Top Length :
?
[SelecType]
Bottom Length :
?
[SelecType]
Side Margin:
?
[SelecType]
Figure 5-34. Menu Transition for Top & Bottom Adjustment
Figure 5-35. Print Pattern for Top & Bottom Adjustment
Self-diagnostic Function
∆
[Paper Feed ]Key: +
∇
[Paper Feed ]Key : –
3.0mm
* Setting is possible in increments of 0.1 mm.
[Enter]
∆
[Paper Feed ]Key: +
∇
[Paper Feed ]Key : –
14.0mm
* Setting is possible in increments of 0.1 mm.
[Enter]
∆
[Paper Feed ]Key: +
∇
[Paper Feed ]Key : –
3.0mm
* Setting is possible in increments of 0.1 mm.
[Enter]
Bottom margin (14.0mm)
Top margin (3.0mm)
Revision A
Side margin
(3.0mm)
242