Errors; Paper End/End Of Roll; Wrong Paper Source Is Selected On Panel; Paper Set Lever Is Released During Operation - Epson Stylus Pro 7600 Service Manual

EPSON Stylus Pro 7600/9600

3.2.2 Errors

3.2.2.1 Paper End/End of roll

Item
LCD PANEL
PAPER OUT
MESSAGE
LED STATUS "PAPER OUT" LED lights up.
The error occurs in following cases.
[A]: Paper is not set.
[B]: The printer detects end of the roll. In this time the paper
Explanation
feed roller holds and keeps the end of the roll.
[C]: The printer completed a printing on a sheet or detects end
of the sheet. In this time the paper feed roller holds and keeps
the end of the sheet.
Set paper.
In the case of [B] and [C] above, remove the paper and set new
paper.
After setting new paper, the error will be cleared. If the printing
data remains in the printer, the printing job will continue on the
newly set paper. When printing job continue, the printer ejects
buffer content, cuts or ejects the paper, and starts printing after
developing new data. Remained data is printed and ejected with
paper length designated with the command.
If the error is not cleared even after paper setting,
Possible causes are problems with the following sensors. Take
Recovery
corrective action as instructed below.
• P_REAR sensor
• P_EDGE sensor
1. Check for paper dust or foreign matters on the sensor and clean
it.
2. Check the operation of each sensor and make AD adjustment in
the self-diagnostics menu.
(Rear AD Adjustment (p.231)
Note: Change the location of the printer if there may be an
effect of any strong external light, such as the sunlight.
Troubleshooting
Table 3-4.
Description
/ Edge AD Adjustment

3.2.2.2 Wrong paper source is selected on panel

Item
LCD PANEL
MESSAGE
LED STATUS
Explanation
Recovery
Table 3-6. LED Indications for Wrong Setting (Roll Paper/Sheet)
PP Command
Roll Paper
Sheet

3.2.2.3 Paper set lever is released during operation

Item
LCD PANEL
MESSAGE
LED STATUS
Explanation
(p.232))
Recovery
Error Display
Table 3-5.
Description
LOAD xxx PAPER
"PAPER OUT" LED lights up.
The LED blinks corresponding to paper path set with PP
command of remote command. (See Table 3-6)
Different paper source is selected on panel from the paper source
that is selected by PP command.
Replace the paper into one that is selected by command, or the
error will be also cleared by toggle the paper source setting on
panel, if only the panel setting is wrong. After it is cleared, it is
ready to print.
Roll paper auto cut Roll paper manual cut
LED LED
Blink Blink
Off Off
Table 3-7.
Description
SET PAPER LEVER
"PAPER OUT" LED lights up.
Paper set lever is released during operation
It is cleared with pushing down the lever, and the printer continues
the operation.
Revision A
Sheet LED
Off
Blink
126