EPSON Stylus Pro 7600/9600
5.2.3.14 Parameter Copying
In actual processing, at each point when the adjusted value is determined in
"5.2.3.13 Round Trip Print Position Adjustment (Bi-D Adjustment)"
compensation value obtained by computation is copied into each area. Actually,
therefore, copy processing by this function is not required.
5.2.3.15 Bi-D2 Adjustment (PG=0.7mm)
When this adjustment is to be performed, use the following paper
C H E C K
since setting must be made for PG=0.7mm.
P O I N T
Paper to be used: Authentic glossy paper
(Example: Photo Glossy Paper #MCSRxxR2)
Make this adjustment, as required, after executing
Adjustment (Bi-D Adjustment)"
(p.248).
The adjustment procedure is the same as that for
Adjustment (Bi-D Adjustment)"
(p.248).
5.2.3.16 Bi-D3 Adjustment (PG=2.1mm)
When this adjustment is to be performed, use the following paper
C H E C K
since setting must be made for PG=2.1mm.
P O I N T
Paper to be used: Authentic plain paper roll (PMSPxxR6)
Make this adjustment, as required, after executing
Adjustment (Bi-D Adjustment)"
(p.248).
The adjustment procedure is the same as that for
Adjustment (Bi-D Adjustment)"
(p.248).
Adjustment
(p.248), the
(See Figure 5-51)
"5.2.3.13 Round Trip Print Position
"5.2.3.13 Round Trip Print Position
"5.2.3.13 Round Trip Print Position
"5.2.3.13 Round Trip Print Position
Self-diagnostic Function
Copy Param. ?
[Enter]
WAIT
Figure 5-51. Menu Transition for Parameter Copying
Revision A
251