Removing The P_Rear Sensor Assy; Removing The Front Cover Sensor Assy - Epson Stylus Pro 10000 Service Manual

EPSON Stylus Pro 10000/10000CF/10600

4.3.3.25 Removing the P_REAR Sensor ASSY

1. Remove the Paper Guide U as described in 4.3.1.11 "Removing Paper Guide U".
2. Disconnect the cable for the P_REAR Sensor ASSY from its connector CN44 on
the C362MAIN Board.
3. Remove two screws (CBS: M2x6) securing the P_REAR Sensor, and remove it.
Paper_Rear sensor
Paper Guide U
Figure 4-163.
4. Release the harness for the P_Rear Sensor ASSY from the cable clamps.
NOTE: When removing/installing the Paper Guide U, be careful not to mar the
P_REAR Sensor ASSY with the edge of the sensor inspection window.
When assembly, 2 places of bosses are combined.
C A U T I O N
If you replace the P_REAR Sensor ASSY, perform the necessary
A D J U S T M E N T
R E Q U I R E D
adjustment listed in Chapter 5.
Disassembly & Assembly
Thank You For Using TheServiceManualShop.com

4.3.3.26 Removing the Front Cover Sensor ASSY

1.
(Without Paper Guide U)
Screws
Thank You For Using TheServiceManualShop.com
Disassembly
Remove the Front Cover as described in 4.3.1.10 "Front Cover Removal".
Front
Cover
Sensor L
Left hinge unit
Figure 4-164.
Revision D
Right hinge unit
182