Csic Reed/Right Error (00010020); Ink Type Error (Setting On Printer Body Side) (00010022); Rtc Analysis Error (00010023) - Epson Stylus Pro 7600 Service Manual

EPSON Stylus Pro 7600/9600

3.2.4.20 CSIC reed/right error (00010020)

Explanation:
At turning on or off the power, at opening or closing the I/C Cover or at
completion of one-page printing, there may be a case where it is impossible to read
the data from the CSIC of the ink cartridge or write the latest ink information in
the CSIC. In such a case, this message is displayed and the printer stops operating.
Cause of trouble:
Read/write for CSIC (ink cartridge) is impossible.
Remedy:
Faulty contact with the CSIC
•
(Deformation of the CSIC contact connector / Replace the Holder Assembly
IC.)
Defective CSIC Board (Replace the ink cartridge.)
•
Replace the CSIC Board (ink cartridge).
•
Tape electric wire out of position
•
Replace the supply valve unit. (Faulty contact with the CSIC)
•
Replace the C472_SUB-B Board (p.192).
•
Replace the MAIN Board (C472 MAIN) (p.207).
•
Troubleshooting

3.2.4.21 Ink type error (setting on printer body side) (00010022)

Cause of trouble:
• An ink type other than dye/pigment has been set.
• "Ink type: neutral" setting with "CSIC detection: OFF" setting.
Remedy:
• Install the correct cartridge.
• With the ink lever released, set "ink type" in
NOTE: If setting is performed with the ink lever in the set position,
initialization will start again and the service call error will
occur again.

3.2.4.22 RTC analysis error (00010023)

Explanation:
There may be a case where the absolute time data stored on NVRAM indicates an
impossible date or hour. In such a case, this message is displayed and the printer
stops operating.
Cause of trouble:
Various values of the absolute time data stored in NVRAM are abnormal.
Remedy:
Initialize RTC (p.83)
1. With the paper set lever in the up position, start
(p.70).
(Power OFF→ [Paper Source] + [Cut/Eject] + [Paper Feed ∇] → Power ON)
2. Input a date and hour in "Initialize RTC" in the counter initialize menu and
turn off the power.
("CLEAR COUNTERS"→ "RTC")
Remove the lithium battery once and install it again.
Replace the lithium battery with a new one.
Replace the MAIN Board (C472 MAIN) (p.207).
Error Display
Revision A
"Maintenance Mode 2" (p.70).
"Maintenance Mode 2"
143