Ac Inlet - Epson Stylus Pro 7600 Service Manual

EPSON Stylus Pro 7600/9600

4.7.2 AC Inlet

Unplug the AC power cable and wait at least five minutes before
C A U T I O N
removing the Power supply Board to make sure there is no residual
power left in the board's capacitors.
1. Remove the Rear Cover. (p.166)
2. Disconnect CN001 from the Power Supply Board.
3. Remove the one screw (M4×8) and toothed washer (M4) fastening the AC Inlet
Ground Cable.
4. Push the hooks (one top and two bottom hooks) and remove the AC Inlet from the
holder. (See Figure 4-82)
Install the AC Inlet in such an orientation that the ground cable
side is positioned up.
Disassembly & Assembly
(See Figure 4-81)
Up: Ground cable
Disassembly and Assembly of Circuit Boards
Screw (M4×8), toothed washer
CN001
Ground cable
AC Inlet Holder
Figure 4-81. Removing the AC Inlet Holder
Hook ×1
Hooks ×2
Figure 4-82. Removing the AC Inlet
Revision A
AC Inlet Holder
AC Inlet
206