EPSON Stylus Pro 7600/9600
1.4.7 Firmware Reload
1.4.7.1 Reload from ROM-DIMM
Reload method from ROM-DIMM is following;
1.
Write RCC format F/W file into ROM-DIMM (C309type).
2.
Switch power OFF and unplug the cable.
3.
Remove the rear cover and insert "1." ROM-DIMM into the exclusive slot.
4.
Switch power ON.
5.
Installation starts and finishes automatically.
6.
Switch power OFF and unplug the cable.
7.
Remove ROM-DIMM from exclusive slot.
8.
Switch power ON.
1.4.7.2 Reload with F/W DOWNLOAD mode
Reload method via parallel interface is following;
1.
Connect the printer to the host with a parallel cable.
2.
Switch power ON pushing Enter + Paper Source + Cleaning buttons.
3.
Check the printer panel displays "F/W DOWNLOAD".
4.
Send UPG format F/W file from the host.
5.
Installation is completed.
Restart the printer (Power Off → Power On)
6.
1.4.7.3 Installation with service utility (F/W Update function)
Installation via parallel interface is following;
1.
Connect the printer to the host with a parallel cable.
2.
Switch power ON.
3.
Check that the printer panel displays "READY".
4.
Send UPG format F/W file from the host service utility.
5.
Installation is completed.
6.
The printer restarts automatically.
Product Description
1.4.7.4 Compulsory start F/W DOWNLOAD mode
When F/W installation fails for some reasons and start up from begins the backup area,
F/W DOWNLOAD mode is automatically selected. See above for more information
about F/W DOWNLOAD mode.
NOTE: This mode is released when F/W installation is completed properly.
Operating Panel
Revision A
85