Epson Stylus Pro 7600 Service Manual page 153

EPSON Stylus Pro 7600/9600
Danger of explosion if the battery is incorrectly replaced.
W A R N I N G
Replace only with the same or equivalent type recommended by
the manufacture. Dispose the used batteries according to
government's law and regulations.
Wear protective goggles to protect your eyes from ink. If ink
gets in your eye, flush the eye with fresh water and see a doctor
immediately.
Wear a pair of gloves to protect your hands from the sharp
edge in the printer mechanism.
If ink comes into contact with your skin, wash it off with soap
and water. If irritation occurs, contact a physician.
Avant de commencer, assurez vous que l'imprimante soit
W A R N I N G
eteinte et que le cordon d'alimentation soit debranche.
Lorsque vous changez la pile au lithium, assurez vous que la
nouvelle respecte bien les caracteristiques requises.
Lorque que vous installez la pile au lithium, faites attention a
l'inserer dans le bon sens en respectant la polarite.
Veillez a jeter les piles usagees selon le reglement local.
Ne rechargez pas les piles au lithium.
Risque d'explosion si la pile est remplacée incorrectment. Ne
C A U T I O N
remplacer que par une pile du même type ou d'un type équivalent
recommandé par le fabricant. Eliminer les piles déchargées selon
les lois et les règles de sécurité en vigueur.
Disassembly & Assembly
Before servicing or performing maintenance on the printer,
C A U T I O N
make sure you have enough space. If you need to move the
printer, make sure the space you move to is safe.
Because the printer is much heavier than most printers you
need to take extra care. If you need to take apart the printer
and the stand from each other or put then together, two people
are necessary.
If you remove and replace any parts of the ink path system, be
sure to discharge the ink beforehand by executing "Ink
Blowing" in "Clean Head" process.
Refer to
After removing any of the ink related parts, double check to
make sure all parts are secured; otherwise you're going to be in
big trouble.
Use only recommended tools for disassembling, assembling or
adjusting the printer.
Apply lubricants and adhesives as specified.
Ink may leak onto other printer parts or the printer basket
when removing printer parts, so it is recommended to put a
sheet or cloth under the printer, especially when working on or
near ink-related parts.
When working on the electrical circuit boards, be careful
concerning static electricity which can cause damage to the
board. It is recommended you use an anti-static wrist band or
similar grounding device to prevent static electricity buildup.
Stylus Pro 7600/9600 uses many FFCs (Flexible Flat Cables).
Improper connection, such as slanting insertion, of an FFC can
cause a short circuit resulting in broken elements on the circuit
board. Be sure to connect the FFCs to the connectors properly
with great care.
Summary
"5.2.3.20 Clean Head (p.256)".
Revision A
153