Parameter Backup; Parameter Backup Procedure; Work Procedure; Others - Epson Stylus Pro 7600 Service Manual

EPSON Stylus Pro 7600/9600

5.1.5 Parameter Backup

5.1.5.1 Parameter Backup Procedure

Required tools:
Flash ROM-DIMM:
C309PROG Board (Part code: 2076654-01)
Parameter backup utility: PBU16.RCC
PC and parallel cable
EPSON page printer: AcuLaser C8600

5.1.5.2 Work Procedure

PREPARATION
1. Prepare the EPSON page printer as specified above. (AcuLaser C8600)
2. Install the flash ROM-DIMM in the optional ROM-DIMM slot (slot "A") on the Main
Board of the page printer.
3. Connect the parallel cable from the PC to the parallel port of the page printer.
4. Turn on the power to the page printer while holding down the following buttons on the
control panel of the page printer:
[Job Cancel] + [Up] + [Down]
5. When the LCD on the control panel of the page printer changes as "ROM A Erasing"
→ "ROM A Format error", send the parameter backup utility file (PBU16.RCC) from
the PC.
6. Transfer of the utility file is completed when the LCD on the control panel of the page
printer changes as "ROM A Writing" → "ROM A Format error". Then the ROM-
DIMM can be used for parameter backup work.
Adjustment
EXECUTION OF PARAMETER BACKUP
1. Remove the Access Cover at the rear of Stylus Pro 7600/9600 and set the prepared
ROM-DIMM in the ROM-DIMM slot on the Main Board.
2. Turn on the power to the Stylus Pro 7600/9600, and the LCD on the control panel will
display "Write:F->M Push:M->F".
3. Upon passage of 5 seconds without pressing any button on the control panel, parameter
backup will automatically be executed. (The contents of NVRAM ("F") on the Main
Board will be copied onto ROM-DIMM ("M").)
4. Backup is completed when the LCD on the control panel changes as "Flash->ROM-
DIMM" → "End [Success]".
5. Turn off the power to Stylus Pro 7600/9600 and take the ROM-DIMM out of the slot
on the Main Board.

5.1.5.3 Others

If you would like to prepare two or more ROM-DIMMs of the same contents as those
of the ROM-DIMM prepared at "PREPARATION" above, follow the following
procedure for efficient work:
1. Prepare the EPSON page printer AcuLaser C8600.
2. Install the flash ROM-DIMMs in the optional ROM-DIMM slots on the Main Board of
the page printer as follows:
Slot "A" = Blank flash ROM-DIMM (for writing)
Slot "B" = Master ROM-DIMM (the one on which the parameter backup file was
written at "PREPARATION")
3. Turn on the power to the page printer while holding down the following buttons on the
control panel of the page printer:
[Start/Stop] + [Job Cancel] + [Enter]
4. When the LCD on the control panel has displayed "ROM Copy Mode", press the
[Enter] button on the panel.
5. Copy processing is executed and completed when the display has changed as "ROM A
Erasing" → "ROM B>A Copying" → "ROM B>A Copying End".
6. Turn off the power to the page printer and take the ROM-DIMMs out of the slots.
Overview
Revision A
218