Cr_Hp Sensor Assy - Epson Stylus Pro 7600 Service Manual

EPSON Stylus Pro 7600/9600

4.3.9 CR_HP Sensor ASSY

When unlocking the carriage, do not move the carriage by about 2
C A U T I O N
cm or more with the cutter pushed into the innermost position;
otherwise, the cutter edge would be damaged.
1. Remove the R Side Cover. (p.160)
2. While pushing the cutter area gently, shift the carriage to the left about 2 cm to unlock
the carriage and then move the carriage to the left from the capping position.
(See Figure 4-24)
3. Release the harness of the CR_HP Sensor ASSY from the four clamps on the printer
body. (See Figure 4-46)
4. Pinch the two upper hooks of the CR_HP Sensor ASSY and disengage them from the
holding plate, and disconnect the connector.
Disassembly & Assembly
(See Figure 4-47)
Disassembly and Assembly of Carriage (CR) Mechanism
Clamp
Clamp
Clamp
Figure 4-46. Releasing the CR_HP Sensor ASSY Harness
Figure 4-47. Removing the CR_HP Sensor
Revision A
Hook
CR_HP Sensor ASSY
183