Cutter Solenoid - Epson Stylus Pro 7600 Service Manual

EPSON Stylus Pro 7600/9600

4.3.4.2 Cutter Solenoid

1. Remove the Cutter Holder ASSY. (p.175)
2. Release the engagement between the Cutter Cap and the CR Lock Kicker, then remove
the Cutter Cap + Cutter Solenoid Iron Core and Cutter Solenoid Spring.
3. Take out the two screws (CP(W): M3×6) holding the Cutter Solenoid, then remove the
Cutter Solenoid by pushing it out from the bottom of the Cutter Holder ASSY with the
shaft of a (+) screwdriver or the like.
Do not pull the cable to remove the Cutter Solenoid.
C A U T I O N
After installing the Cutter Solenoid, the following adjustment
A D J U S T M E N T
R E Q U I R E D should be done.
"5.1.4.11 Cutter Solenoid ASSY or Paper Guide L Adjustment
(p.217)"
Disassembly & Assembly
Screws (CP(W): M2.5×5) ×2
Disassembly and Assembly of Carriage (CR) Mechanism
Cutter Cap
Cutter Solenoid
Push
Figure 4-36. Cutter Solenoid Removal
Revision A
CR Lock Kicker
177