Front Cover - Epson Stylus Pro 7600 Service Manual

EPSON Stylus Pro 7600/9600

4.2.9 Front Cover

1. Open the Front Cover.
2. Push in the two hooks to the left of the cover and remove the Front Cover Support.
(See Figure 4-22)
3. Release the Front Cover Spring L from the Front Cover Spring Catch Shaft on the left
side of the Front Cover. (See Figure 4-23)
4. Remove the Plastic Stop Wheel E5 on the left side of the Front Cover and move the
Front Cover Fulcrum Pin outward for its removal.
5. Release the Front Cover Spring R from the Front Cover Spring Catch Shaft on the right
side of the Front Cover.
6. Remove the Front Cover from the Front Cover Fulcrum Pin R.
Install the Plastic Stop Wheels in the correct orientations,
respectively.
Long
Front Cover Fulcrum Pin L
The cover switch holder installation position should be checked so
A D J U S T M E N T
R E Q U I R E D that the cover sensor ASSY is linked to the front cover when it
opens and closes.
Refer to "5.1.4.9 Cover Sensor ASSY Adjustment" (p.216)
Disassembly & Assembly
Front Cover Support
Front Cover
Plastic Stop Wheel E5
Short
Front Cover Fulcrum Pin L
Removing the Panel Unit and Housing
Hooks
Front Cover
Figure 4-22. Front Cover Support Removal
Front Cover Spring Catch Shaft
E-ring
Front Cover Spring L
Plastic Stop Wheel E
Figure 4-23. Front Cover Removal
Revision A
Front Cover Fulcrum Pin R
Front Cover Spring R
Front Cover
170