Lcd Indications In Normal Mode - Epson Stylus Pro 7600 Service Manual

EPSON Stylus Pro 7600/9600

1.4.2.2 LCD Indications in Normal Mode

Table 1-27. Indications (in Normal Mode)
Functions
Ready to print READY
Processing data PRINTING
In power OFF sequence POWER OFF
In ink sequence WAIT
Initial filling INK CHARGING nnn%
Pause PAUSE
Reset RESET
Initializing WAIT
Waiting for paper initialize start PRESS PAUSE BUTTON
trigger
Initializing paper WAIT
Out of paper PAPER OUT
Difference with roll paper and LOAD XXX PAPER
sheet
Paper set lever is released LOAD PAPER
Paper jam PAPER JAM
Cover open COVER OPEN
Paper set lever is released during SECURE PAPER LEVER
operation
Paper cutting error PAPER NOT CUT
Paper not straight PAPER NOT STRAIGHT
Paper check error RELOAD PAPER
End of roll PAPER OUT
Problem with paper output (sheet) RELOAD PAPER
Ink out INK OUT
Ink low INK LOW
No ink cartridge NO INK CARTRIDGE
Defective ink cartridge SET INK CARTRIDGE
Wrong cartridge WRONG CARTRIDGE
Product Description
LCD panel display Indicator
*2
*2
*2
*3
Table 1-27. Indications (in Normal Mode) (continued)
Functions
PG
Command error
setting
Type B interface error
*1
Fatal error
*1
Maintenance request
Timer IC reset/NVRAM clear
*1
After replacing ink cartridge
Ink cover open
Wrong ink cartridge (dye/
pigment)
Non-genuine cartridge
Maintenance tank almost full
warning
Maintenance tank full
No maintenance tank
Unable to print error
Paper is too thick for cleaning
Ink is not enough for cleaning
Ink cartridge replacing
Ink drying
Restart request
Restarting request
Note *1: When PG setting = WIDE or WIDER, "W" is displayed at the left of lower line.
When PG setting = NARROW, "N" is displayed at the left of lower line.
*2: Ink remaining / available rate of maintenance tank are displayed with indicator.
*3: Suction is displayed with indicator.
*1 *4: Character strings on the second line resulting from line feed above are displayed on
the second line of LCD panel.
*5: It is displayed only for page delay.
NOTE: For details of error display, refer to
Operating Panel
LCD panel display Indicator
COMMAND ERROR
OPTION I/F ERROR
SERVICE. REQ. nn
MAINTENANCE REQ. nn
WAIT
CLOSE INK CART. COVER
WRONG CARTRIDGE
INVALID CARTRIDGE
MAINTENANCE TANK
ALMOST FULL
MAINTENANCE TANK FULL
NO MAINTENANCE TANK
UNABLE TO PRINT
REMOVE PAPER
NOT ENOUGH INK
SET INK CARTRIDGE
INK DRY nn MIN
TURN PRINTER PWR OFF AND
THEN ON
TURN PWR OFF AND ON
"3.2.1 Errors (p.123)".
Revision A
PG
setting
*1
*5
34