Removing And Replacing The Bezel - IBM eServer xSeries 445 Type 8870 Option Installation Manual

Removing and replacing the bezel

Complete the following steps to remove and replace the server bezel.
Figure 11. Removing the bezel
v Complete the following steps to remove the bezel:
v Complete the following steps to replace the bezel:
16
xSeries 445 Type 8870: Option Installation Guide
1. Press on the two tabs at the top edge of the bezel; then, pull the top of the
bezel slightly away from the server.
2. Press on the two tabs at the bottom edge of the bezel; then, pull the bezel off
the server. Store the bezel in a safe place.
1. Align the four tabs with the slots in the server chassis.
2. Press firmly against the front of the bezel until it snaps into place.