Reassembling; Installing The System Air Duct - Fujitsu PRIMERGY TX150 S8 Upgrade And Maintenance Manual

Basic hardware procedures
4.5

Reassembling

V
CAUTION!
Before attaching the covers, make sure no unnecessary parts or tools
●
are left inside the server.
In order to comply with applicable EMC regulations (regulations on
●
electromagnetic compatibility) and satisfy cooling requirements, the
server must not run while the top / side cover is removed.
For further safety information, please refer to chapter
●
information" on page
4.5.1

Installing the system air duct

Figure 17: Installing the system air duct
Ê Hold the system air duct by the two green touch points and lower it into the
chassis until the green locking latch clicks in (see close-up).
64
35.
Upgrade and Maintenance Manual
"Important
TX150 S8 / TX200 S7